Empire Products BF-10-2 Owner's Manual download pdf (Page 14)

16943-10-0314Page 14

1. Spark electrode does not produce spark.

a. Spark electrode broken - replace.

b. Ignitor wire may not be attached to spark electrode -

attach.

c. Ignitor wire damaged - replace.

d. Piezo ignitor defective - replace.

2. Spark electrode produces spark but pilot does not light.

a. No gas to heater - turn on gas.

b. PILOT position not properly aligned - turn gas control knob

to PILOT position and depress.

c. Pilot is blocked from spider web or dirt - clean pilot, see

Figure 12, Page 12.

3. Pilot ame does not stay "ON" when control knob is

released.

a. Control knob in PILOT position not completely depressed or

held in long enough.

b. INTERLOCK latching device is operative - see "Lighting

Instructions," Page 10, Step 9.

c. Thermocouple lead not tightened into gas control - tighten

thermocouple lead.

d. Pilot ame not surrounding thermocouple - clean pilot, see

Figure 12, Page 12.

e. Inlet gas pressure too low, contact gas supplier.

f. Thermocouple defective - replace pilot.

g. Gas control defective - replace.

4. Main burner does not ignite.

a. Main burner orice is blocked - clean, see "Main Burner

Flame Characteristics," Page 11.

b. Inlet gas pressure too low, contact gas supplier.

5. Heater keeps shutting "OFF" during normal operation.

a. Pilot is blocked - clean pilot, see Figure 12, Page 12.

b. Inlet gas pressure too low, contact gas supplier

SYMPTOMS - POSSIBLE CAUSES AND CORRECTIONS

TROUBLESHOOTING

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Empire Products BF-10-2 Owner's Manual Page 14