Empire Products BF-10-2 Owner's Manual download pdf (Page 8)

16943-10-0314Page 8

SRS-18* and SRS-30 Floor Stand Installation

1. Align clearance holes on oor stand with screw holes on bottom

of heater, as shown in Figure 5.

2. Attach oor stand to heater with (4) screws provided with oor

stand.

3. Connect the gas line.

* SRS-18 floor stand can not be used in a bedroom

installation.

BF-10 must be wall mounted in a bedroom installation.

Installation on Rugs and Tile

If this appliance is installed directly on carpeting, tile or other com-

bustible material, other than wood ooring, the appliance shall be

installed on a metal or wood panel extending the full width and

depth of the appliance.

Attention: Optional SRS-18 and SRS-30 Floor Stand meets

requirement.

The base referred to in this section does not mean the re-proof

base as used on wood stoves. The protection is for rugs that are

extremely thick and light colored tile.

Figure 5

BF-30

Figure 4

BF-10 and BF-20

Figure 3

When facing the front of the appliance the following minimum clearances to combustible construction must be maintained.

Do not install in alcove or closet.

Provide adequate clearances around air openings.

Adequate accessibility clearances for purposes of servicing and proper operation must be provided.

BF-10/BF-20 BF-30

Left side 5" (127mm) 8" (203mm)

Right side 5" (127mm) 8" (203mm)

Rear wall 0" (0mm) 0" (0mm)

Ceiling 36" (914mm) 36" (914mm)

Minimum vertical clearance from a projections

above the appliance (shelves, window sills, etc.)

36" (914mm) 36" (914mm)

Floor (top surface of carpeting, tile, etc.) 2" (51mm) 2" (51mm)

CLEARANCES

OPTIONAL FLOOR STAND INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

No comments

Empire Products BF-10-2 Owner's Manual Page 8