Empire Products BF-10-2 Owner's Manual download pdf (Page 18)

16943-10-0314Page 18

PARTS LIST

Wiring

The appliance, when installed, must be electrically grounded in

accordance with local codes or, in the absence of local codes, with

the National Electrical Code, ANSI/NFPA 70, if an external electrical

source is utilized. This appliance is equipped with a three-prong

[grounding] plug for your protection against shock hazard and should

be plugged directly into a properly grounded three-prong receptacle.

Do not cut or remove the grounding prong from this plug. For an

ungrounded receptacle, an adapter, which has two prongs and a

wire for grounding, can be purchased, plugged into the ungrounded

receptacle and its wire connected to the receptacle mounting screw.

With this wire completing the ground, the appliance cord plug can

be plugged into the adapter and be electrically grounded.

WARNING

Label all wires prior to disconnection when servicing controls.

Wiring errors can cause improper and dangerous operation.

Verify proper operation after servicing.

Blower Motor

The blower motor does not have oiling holes. Do not attempt to

oil the blower motor.

Blower Wheel

The blower wheel will collect lint and could require periodic cleaning.

If the air output decreases or the noise level increases, it indicates

a dirty blower wheel.

To clean blower wheel:

1. Turn OFF gas supply to the heater.

2. Turn OFF electrical supply to the heater.

3. Remove lower louver from casing assembly (2 screws).

4. Remove reector from casing assembly (2 screws).

5. Remove upper louver from casing assembly (2 screws).

6. Clean blower wheel with a vacuum cleaner.

7. As parts are being replaced in reverse order, check for gas

leaks at all gas connections before lower louver is replaced

onto casing assembly.

WARNING

Unplugging of blower accessory will not stop the heater from cy-

cling. To turn off gas to the unvented heater: Push in gas control

knob slightly and turn clockwise to "OFF." Do not force.

If any of the original wire as supplied with the appliance must be re-

placed, it must be replaced with type 125°C wire or its equivalent.

OPTIONAL BLOWER INSTALLATION INSTRUCTIONS (continued)

INDEX

NO.

PART

NO. DESCRIPTION

1 R-2396 BLOWER (INCLUDES MOTOR, FAN,

AND FAN HOUSING)

2 R-2503 FAN CONTROL

3 R-2395 WIRE ASSEMBLY

4 R-1465 BUSHING - HEYCO #SR5KN4

5 VF-068 CORD SET ASSEMBLY

6 SR-196 BLOWER PAN (BF-10, BF-20)

6 SR-198 BLOWER PAN (BF-30)

7 R-1499 RUBBER GROMMET (4 REQUIRED)

8 R-1454 BRASS BUSHING (4 REQUIRED)

N/S SR-219 BLOWER HARDWARE PACKAGE

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Empire Products BF-10-2 Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Fireplaces Empire Products BF-10-2